Experimental analysis of combined side weir-gate located on a straight channel

Flow measurement and control in open channel system for lateral flow is important to support the system management. The flow characteristics of combined side weir-gate are complicated due to changes in flow conditions along the side weir-gate section. Experimental investigation of the flow characteristics of both weir and sluice gates is crucial for predicting the flow through a combined side weir-gate structure. Although weir-gate structures are widely used for frontal flow in hydraulic structures, the same is not true for lateral flows. In this study, 650 laboratory tests were conducted to determine the flow characteristics of combined side weir-gate for subcritical flow, and the experimental results were analyzed to determine the effect of these characteristics and weir-gate geometry on discharge capacity. Interaction factor of combined side weir-gate is a function of the upstream Froude number, the ratio of gate opening to upstream flow depth, the ratio of distance between the top of the sluice gate and the weir crest to gate opening, the ratio of weir and gate length to upstream flow depth, and the ratio of weir and gate length to main channel width. Consequently, more discharge is passed through combined side weir-gate compared to side weir and sluice gates. The empirically derived equations for the discharge of combined side weir-gate show good compatibility with the experimental data.     

A study on the thermoelectric properties of ALD-grown aluminum-doped tin oxide with respect to nanostructure modulations

The thermoelectric properties of aluminum-doped tin oxide (ATO) thin films synthesized by thermal atomic layer deposition (ALD) were studied with respect to the aluminum concentration. The overall aluminum content in each layer was modulated by adjusting the relative number of tin oxide (SnO₂) and aluminum oxide (Al₂O₃) growth cycles, where a sequential process involving n cycles of SnO₂ growth followed by 1 cycle of Al₂O₃ deposition was performed (building up a super-cycle). The electrical conductivity (620 S/cm), free carrier concentration (1.23x10²¹ cm^-3), and power factor (0.49 mW/K²m) increase until their maximum values are reached when the Al content is approximately 1.50 at% of the cations, and decrease as more Al is added in. On the other hand, the Seebeck coefficient decreases monotonically as the Al content increases up to about 2.88 at%, and begins to increase with further Al doping. Here the thermoelectric efficiency is therefore determined primarily by the free carrier concentration, while the Seebeck coefficient appears to be influenced by the overall crystal structure.     

Critical roles of the rhombohedral-phase inducers in morphotropic NaNbO3-BaTiO3-ABO3 quasi-ternary lead-free piezoelectric ceramics

A morphotropic phase boundary (MPB) between rhombohedral (R) and tetragonal (T) phases was identified in a few (0.9-x)NaNbO₃-0.1BaTiO₃-xABO₃ (x?=?0–0.05) lead-free systems. Critical roles of R-phase inducers were specially evaluated in terms of phase boundary position, microstructure and piezoelectric responses. The results indicate not only the tolerance factor of the ABO₃ additive but also its ferroelectricity and corresponding volume change would influence the formation of phase boundary and further determine dielectric and ferroelectric responses. The piezoelectric coefficient d₃₃ of MPB compositions was compared with theoretically-calculated d_33-cal according to d₃₃?=?2P_r·ε₃₃·Q₃₃, demonstrating that the piezoelectric response of these systems should be determined by combined effects of the phase coexistence, nano-scale domains and particularly enhanced dielectric responses. The largest d₃₃ ～305 pC/N, the highest ε₃₃^T/ε_o ～2815 and the lowest P_r ～14.7 μC/cm² were achieved in the MPB composition with 3.75% SrZrO₃. These experimental results provide a valuable reference for designing new NaNbO₃-based lead-free piezoelectric materials.     

Structure,stability and permeation properties of NaA zeolite membranes for H2O/H2 and CH3OH/H2 separations

NaA zeolite membranes were synthesised in the secondary growth hydrothermal method based on the seeding of the inner surface of a ceramic α-alumina tube. The impacts of crystallisation time and zeolite precursor concentration (in H₂O) were investigated. The structure and stability of the prepared NaA zeolite membranes were also investigated with operating temperatures, times and pressures. The results indicate that the optimal synthesis gel molar composition was 3Na₂O: 2SiO₂: Al₂O₃: 200H₂O. This led to cubic-shaped NaA zeolite which showed good stability. The optimal NaA zeolite membrane had H₂O and CH₃OH fluxes of 2.77 and 0.19 kg/m²h, with H₂O/H₂ and CH₃OH/H₂ separation factors of ∞ and 0.09 at a temperature of 30 °C. The NaA zeolite membrane had high thermal stability, but poor separation performance at high temperature (240 °C). The results suggested that the H₂ permeation flux is significantly influenced by preferential adsorption of vapour in the NaA zeolite membrane.     

钢轨交流闪光焊接过程过梁爆破特征分析

以高速摄影技术作为主要研究手段，研究钢轨交流闪光焊接过程过梁爆破特征，并结合热成像系统采集焊接过程温度场，以此为数据基础定量分析了钢轨交流闪光焊接过梁爆破特征. 结果表明,钢轨交流脉动闪光焊接工艺模式下，加速闪光阶段具有几个阶段中最高的闪光频次46.93次/s，脉动闪光阶段具有最低的闪光频次11.07次/s；连续闪光阶段闪光烈度为0.009 2 mm/次，是几个阶段中最强的，脉动阶段的闪光烈度最弱，为0.003 8 mm/次；从闪光加热因子来看，脉动阶段最高，符合了该阶段积累热量的主要目的；加速闪光阶段最低，是由于该阶段为了制造保护气氛产生的气化过梁带走了较多的热量；从闪光均匀度看，闪光最不均匀的阶段是闪平阶段，最均匀的阶段是脉动阶段，这恰恰说明了两待焊端面的微观平行情况在闪平阶段最差、脉动阶段最佳.     

近似完全匹配层边界条件吸收效果分析及衰减函数的改进

完全匹配层边界条件存在两个问题，一是如何减少实际应用带来的额外存储量以及提升计算速度，另一个是如何提升匹配层的吸收效果。对于第一个问题发展了多种非分裂形式，本文采用一种直接对波场进行变换的新型非分裂方法，相比卷积完全匹配层具有不改变方程的形式以及易于实现等优势。对于如何进一步提升完全匹配层吸收效果，没有太大的进展。这是因为离散差异使匹配层的吸收问题更为复杂，一般采取增加匹配层层数的措施缩小离散差，但是又会导致计算量和存储量的增加。本文以在不增加匹配层层数以及不减小理论误差的情况下减小离散差异所带来的虚假反射为目的，分析传统的衰减因子，研究匹配层的吸收机理，设计新的衰减因子，以提高完全匹配层的吸收性能。新衰减因子能够进一步削弱虚假反射振幅，在匹配层层数为5~20层时，对应的边界反射振幅只有改进前的40%~80%。     

多中心治理视角下经济与生态共赢的路径与启示

改革开放40年来,我国经济飞速发展的同时也产生了一系列的生态环境问题,土壤重金属污染问题尤为严重。上世纪80年代,江西贵溪地区数家大中型冶炼、化工类企业在九牛岗区域逐渐集中,由于长期对资源的粗放型开发,高耗能、高污染、高排放加之低效率生产对贵溪J区域农田造成了严重污染,土壤重金属含量严重超标,生态环境遭到破坏。污染治理过程中,各相关主体从“各自为政”到“共同发力”,从长期得不到有效解决到多主体相互协作综合治理取得成效,走出了一条政府主导,企业主体,村民参与,社会支持的土壤重金属污染治理新路。本文着重就自然资源、环境保护与社会经济如何协调发展,探索运用多中心治理理论对土壤污染治理进行实践,推动经济发展与生态环境和谐共进。     

Economic Indicators

Currency exchanges rates – updated monthly. Economic indicators of industrial production. Countries included: France, Germany, Italy, the United Kingdom, the United States, Canada, Japan (Total G-7), Eurozone and Total EU-28 (Total OECD). Updated monthly. Economic indicators of car registration in the United States, Canada, France, Germany, Italy, Poland, Spain, Turkey, the United Kingdom, Japan, Republic of Korea and Other OECD (Total OECD-30). Updated monthly. Monthly averages of crude steel production in thousand metric tons for the United States, Canada, Brazil, Mexico, Austria, Belgium, Czech Republic, France, Germany, Italy, Netherlands, Poland, Spain, Sweden, Turkey, the United Kingdom, Russia, Ukraine, South Africa, Iran, China, India, Japan, Republic of Korea, Taiwan and Australia.     

蓝宝石晶体掏棒机内冷式刀柄辅具结构研究

因蓝宝石晶体硬度为莫氏9级,仅次于最硬白金刚石,蓝宝石晶体掏棒加工中会产生很高的切削热量,筒刀和晶体必须进行筒刀内部和外部同时强力冷却,才能保证掏棒加工的稳定性和晶棒质量。所以蓝宝石晶体掏棒加工中要解决的关键技术问题之一,是内冷式刀柄辅具结构的研究、设计、试制、改进和联机使用。     

船用淡水泵泵轴开裂的仿真分析及改进

针对某船用淡水泵泵轴开裂故障，建立泵轴有限元模型，并采用应力-疲劳理论和线性累积损伤模型，基于安全系数法分析了泵轴的高周疲劳损伤。结果表明:泵轴键槽为结构疲劳薄弱区域，疲劳安全系数不足导致键槽处产生疲劳裂纹,裂纹扩展,直至开裂失效。仿真和试验验证表明:取消键槽并加大轴径的改进措施成效显著；泵轴的疲劳安全系数得到提高，满足材料的许用要求。